Products

Feeder Installation

Remove the feeder from the box and inspect thoroughly for any signs of damage, even if the box does not show damage. If you notice any damage (cracked covers, damaged timer, broken lid, etc.) please stop, and contact your dealer immediately.

Open the battery cover and install two AA (1.5V) batteries. DO NOT use rechargeable batteries. If the symbol LO appears on the display, the batteries being installed need to be replaced.

Adjust feed dispensing door to the maximum setting. Slide hopper off of feeder and fill with flake, pellet, or powder fish food. Slide hopper back onto feeder and close dispensing door.

If refilling the feed hopper, be sure the hopper is cleaned before refilling with new food. This will help prevent food spoilage.

Adjusting Feed Amount

By adjusting the feed dispensing door, the amount of food dispensed at each feeding can be set. Simply adjust dispensing door to desired setting and press the MANUAL button to measure how much feed will be dispensed in one feeding. Adjust dispensing door as desired.

NOTE As a general rule, aquarium fish only need to be fed 1-3 times daily. Feed only the amount of food the fish will consume in 5-10 seconds. Over feeding can cause cloudiness, ammonia problems, and can create a deadly imbalance in the aquarium.

AquaChef Can Be Installed Two Ways

Using the mounting bracket included, screw the bracket frame to the lip of the aquarium. Place the base of the feeder onto the bracket frame. Adjust the feeder by sliding on the bracket to ensure that fish food is dispensed directly into the aquarium.

If the bracket cannot be mounted onto the aquarium, use the double-sided tape to mount base of feeder to the lid. Always ensure food is dispensed directly into the aquarium. When installing, make sure that the feeder can never fall into the water (warranty is void if feeder is ever submersed, or falls into the water). Also, make sure it is in a location that allows you to refill it easily.

Test feeder by pressing the "M" button on the timer and ensure that the feed drops into the water and not onto the ground or around the tank.

PROGRAMMING THE TIMER

Button Description

MODE+- Button Local time and feeding time are set by this button.

SET+- Button After pressing the MODE button, the SET button allows the respectively displayed times to be changed.

ADJUST+- Button After pressing the SET button, the respectively effected symbol (either time or feeding mode) blinks and can be set to a higher number with a "+" or lower number with "-" button.

MANUAL Button Automatically rotates the hopper once for a single manual feeding.

SET THE CLOCK

Press SET button once and hours will blink.

Press the ADJUST button to set hour time.

Press MODE and minutes will blink.

Press the ADJUST button to set minutes.

Press SET again and the current time will be displayed. The timer operates on a 2400 hours cycle, therefore, 5 p.m. = 17.00 hours.

SET THE FEEDING TIME

Press the MODE button, 0000 will be displayed.

Press the SET button, hours blink.

Press the ADJUST button to program hour of first feeding time.

Press the MODE button to program the minutes of the first feeding time.

Press MODE again and the "1" digit will appear. This indicates a single feeding at this programmed interval. By pressing ADJUST again, the display with change to "11" indicating a double feeding will occur at this programmed interval. Each feeding will be separated by a 60 second interval.

Press SET again and first the feeding interval program will be complete.

PROGRAMMING ADDITIONAL FEEDINGS

Repeat the steps above for programming additional feedings. The feeder can be programmed for up to 4 times daily. When the MODE button is pressed in four times sequentially, the timer will skip to the next feeding interval.

DELETING A FEEDING PROGRAM

Press MODE program to find program that will be deleted.

Press SET to select the program.

Press MODE twice and the number of the program will blink.

Press ADJUST to delete program.

Press SET to confirm deletion.

MANUAL OPERATION

Press MANUAL button, feeder will automatically dispense one feeding.

To reset feeder, remove batteries and wait 1 minute. Replace batteries.

click to see more

Holds pellet or flake food

Dispenses dry medication

Feeds one to 4 times a day

Perfect for vacations and daily maintenance

No batteries to fail or misplace

Hopper holds up to a 4 month supply of fish food

• UL Listed 115V 2.7W
• No Batteries Needed

click to see more

More!

click to see more

Battery operated fish feeder. One touch setting, three simple feeding programs.

Anti-drip design prevents humidity infiltration which keeps food fresh and crisp.

Airpump inlet allows optional use of airpump to keep food dry. Unit takes 2 AA

batteries, not included.

• Length - 6"

click to see more

Every Day Fish Feeder

• Great for everyday use whether you're home or away! Reliably dispenses accurate portions to prevent over or underfeeding of fish. Fits on most aquariums!
• Easy to set-up
• Easy digital programming for up to a maximum of 8 feedings per day
• Splash-proof buttons
• Ideal for most types of food, for fresh water and marine fish.
• Transparent drum
• Manual release button allows for feeding outside pre-programmed times
• Battery operated, includes 2 AA batteries
• 2-stage low battery level indicator

click to see more

This versatile feeder may be mounted on the aquarium hood, on a condensation tray, or on the brackets provided.

* Reliable and accurate quartz timer

* Over 1 year's continuous use from 1x AA battery

* Battery condition indicator

* Serves up to 14 individual meals while you are away

* Food served over several hours - keeps fish active and reduces danger of over feeding

* Accurate feeding of all fish foods, including flake

* Easy to use timer provides from 1 to 4 meals per day

• 1 ?" x 4 11/16" x 5 ?"; Holds 5/8" x 5/8" x ?" per meal; .71lbs

click to see more

click to see more

Two Little Fishies' NanoMag is an itsy-bitsy, lean, high-energy, window-cleaning apparatus. Its patent-pending design provides flexibility and a slender profile that slips safely between polyps and viewing windows. It's got the umph needed for cleaning glass up to 3/8 thick. The NanoMag also glides across the curved surfaces of fish bowls, wiping off algal films with ease, and it's so much fun to use you just might have to take turns.

click to see more

For ponds and large aquariums, the P21 will dispense food slowly over a 5 hour period for approx. 21 days. The fully weatherproofed P21 may be pole-mounted at waters edge or suspended over the water.

* Reliable and accurate quartz timer

* Over 1 year's continuous use from 1x AA battery

* Battery condition indicator

* Feeds approximately 21 daily meals while you are away

* Food served over several hours - keeps fish active and reduces danger of overfeeding

* Adjustable feed quantity and timing for all fish foods

* Easily suited to all ponds and large aquariums

• 7" X 7 1/8" X 3 3/8"; Holds 1 ? cups in drum; 1.69 lbs

click to see more

click to see more

click to see more

The Eheim Twin Fish Feeder has two feeding containers for all kinds of food--granules, sticks, pellets, and flakes

• Two types of food can be given at the same time, providing the best possible feeding for all types of fish and all areas of the aquarium
• Feeder is aerated to prevent food sticking
• Each chamber can be programmed individually
• ""Random Feed"" function replicates natural feeding
• Large display

click to see more

Unique plastic clip with a large suction cup that securely holds Julian Sprung`s SeaVeggies with a powerful grip. Attaches easily and holds firmly to the aquarium glass. Unlike other clips, ours floats, so it is easy to retrieve and won`t get lost in the aquarium decorations. No metal parts. For marine & freshwater aquariums.

click to see more